Nephrology · Planning Calculator · Dialysis Unit Operations

Dialysis RO Water & Reject-Reuse Estimator

Turn metered reverse osmosis (RO) readings into recovery, liters per completed session, and a mass-balance check, then estimate how much fresh water approved nonclinical reuse of reject could displace, capped by real demand.

Published: Read time:

← All calculators & tools  ·  Climate extremes & kidney care guide →

Instructions
  1. Read the RO feed and permeate meters (and reject, if metered) at the start and end of the same interval, on the same boundary.
  2. Enter completed HD sessions in that interval and your facility's metering tolerance.
  3. Optionally choose a reuse mode, the engineering-approved recoverable fraction or measured capture, and the eligible nonclinical demand it would replace.
  4. Read recovery, per-session volumes, the residual, and the modeled displacement. Treat flagged results as prompts to check meters, not as findings.

All computation runs in your browser; no values are stored or transmitted.

When to Use

Use it for baseline water accounting, to track liters per completed treatment over time, and to size a proposed reuse project for engineering and infection-prevention review.

⚠️

When not to rely on it

Not for setting dialysate flow or treatment time, approving emergency water sources, or judging dialysis-water quality. Reject reuse requires approved nonclinical use, water characterization, cross-connection protection, and engineering oversight.

Pearls & Pitfalls
💡

Reject is not spent dialysate

RO reject is concentrated feed water discarded by the membrane before treatment. Used dialysate is clinical effluent and is excluded from this estimate.

🔬

Reuse does not shrink RO feed

Reusing reject replaces fresh water used elsewhere in the facility. The RO still draws the same feed; the saving appears on the building meter, not the RO meter.

🚫

Pitfalls

(1) Mixing meter intervals or boundaries. (2) Forcing a mass balance that does not close; recycle loops and bypass flows need their own meters. (3) Claiming displacement without matched demand, storage, and timing. (4) Treating the KDIGO-reported 20%–80% reject range as a default.

Dialysis RO Water & Reject-Reuse Estimator

Metered over the interval.
Same meter boundary and interval as F.
If blank, R is estimated as F − P.
Facility-set; used for the mass-balance check.
Toilet flushing, grounds, cleaning approved by engineering.

Enter feed and permeate to begin.

⚕ Water accounting and a modeled reuse estimate only. It does not set treatment parameters, approve emergency water, or replace engineering and infection-prevention review.

Evidence & References

Formula

QuantityFormula
RecoveryP ÷ F (if F > 0)
Reject (estimate)F − P, only for a reconciled simple boundary
Mass-balance residualF − P − R, flagged beyond the facility tolerance; reuse suppressed if flagged
Per sessionF ÷ N and R ÷ N (if N > 0)
Modeled displacementmin(R × a, D) or min(measured capture, D)
Tariff sensitivitydisplaced L ÷ 1,000 × PHP per m³ (gross)

References

  1. Barraclough KA, Berman-Parks N, Jha V, et al. Green dialysis: environmentally sustainable care, growth, and innovation — conclusions from a KDIGO Controversies Conference. Kidney Int. 2026;110(1):42-60. doi:10.1016/j.kint.2026.01.015
  2. Department of Health (Philippines). Administrative Order No. 2013-0003: Implementing guidelines in the analysis, monitoring and maintenance of water used in dialysis facilities. 2013.
Important: This is a descriptive planning aid for dialysis engineers, infection-prevention leads, and medical directors. Synthetic example: F 30,000 L, P 12,000 L, R 18,000 L, 100 sessions, a 0.6, demand 8,000 L gives 40% recovery, 300 L feed per session, and 8,000 L modeled displacement. It does not replace water-quality testing under DOH Administrative Order 2013-0003.
Dr. W Rivero, MD

W Rivero, MD, FPCP, DPSN

Specialist in Internal Medicine, Nephrology, and Clinical Nutrition. Practicing integrative and evidence-based nephrology across Quezon City, Pampanga, and Bulacan.

· Book an Appointment →

QR code — scan to save Dr. Rivero's contact info

Scan and save